Boiler Installation Headland

Frequently Asked Questions About Boiler Installation

What is a boiler's BTU rating?

A BTU (British Thermal Unit) measures the amount of heat energy a boiler can produce in an hour. It indicates the heating capacity of the boiler. The BTU rating you need will depend on the size of your home or business, the level of insulation, your desired temperature, and the climate. A qualified heating engineer can calculate the correct BTU rating for your specific requirements. Choosing the right BTU rating is crucial for efficient and cost-effective heating.

How do I bleed my radiators?

If your radiators have cold spots or are not heating up efficiently, they may need to be bled to remove trapped air. Here's how to bleed your radiators: :1. Turn off your central heating system and wait for radiators to cool.2. Locate the bleed valve on the radiator. It's usually a small, square-shaped valve on one of the top corners. .3. Place a radiator key if you don't have a radiator key on the bleed valve and slowly turn it counterclockwise. . Air trapped in the system will escape during this process.4. Hold a cloth or container under the valve to catch any fluid that may drip.5. Continue turning the key until the hissing stops and water starts to come out steadily. .6. Tighten the valve clockwise .7. Repeat this process for all the radiators in your home.8. Once you have bled all the radiators, turn your central heating system on and check the pressure gauge on your boiler. . Confirm that your system pressure is in the normal range for optimal boiler performance. If not, consult with a professional HVAC technician. Adjust the pressure if needed. If you are unsure how to do this, consult the manufacturer’s instructions or call a Gas Safe registered heating engineer. By bleeding radiators, you can improve their effectiveness and the overall performance of your central heating system.

What is a boiler’s AFUE rating?

The AFUE rating measures how efficiently a boiler converts fuel to heat over a year. It's expressed as a percentage. For example, an AFUE of 90% means that 90% of the fuel energy is converted into heat for your home, with only 10% wasted. . The higher the AFUE, the more efficient the boiler and the less fuel you'll need to heat your home, resulting in cost savings.. Prioritize energy efficiency when choosing a boiler to reduce costs and your carbon footprint.

How do I repressurize my boiler?

If the pressure gauge on your boiler shows low pressure, you'll need to repressurize the system. Repressurizing is a straightforward process:1. Turn off your boiler and allow it to cool.2. Locate the filling loop. This is usually a flexible braided hose connected to your mains water supply and boiler, under the unit. Sometimes, the loop is built in; other times, it is external. 3. Open both valves on the filling loop slowly, If your boiler uses a lever-type handle, consult the manual. You should hear water flowing into the system. .4. Keep an eye on the pressure gauge. When the pressure reaches the appropriate pressure, close both valves on the filling loop turning clockwise.5. Turn your boiler back on. If the pressure is still low, repeat the process.. If you're not sure how to repressurize your boiler, it's best to consult a professional. Incorrectly repressurizing the system can cause damage.