Boiler Installation Spokane

Frequently Asked Questions About Boiler Installation

What is a condensing boiler?

A condensing boiler is a very efficient boiler. They recapture and reuse exhaust heat. This recovered heat is used to preheat the cold water returning to the boiler, reducing the amount of energy required to raise the water temperature for your heating and hot water. . As a result, condensing boilers are much more efficient than traditional boilers, which means lower energy bills for you.

How long does it take to install a boiler?

Boiler installation typically takes between [Time Range], depending on several variables. Additional factors that may affect installation time include the accessibility of the installation location and the condition of your existing plumbing. Your installer can provide a more accurate timeline after assessing your specific situation. .

What is a power flush, and do I need one for my new boiler?

A power flush is a deep cleaning of your central heating system, using specialized equipment to remove sludge, rust, and other debris that can build up over time. This buildup can restrict water flow, reduce heating efficiency, and cause damage to your boiler and other components.While not always strictly necessary with a new boiler, a power flush is often recommended, especially if you're replacing an older system. It ensures that your new boiler is installed in a clean and efficient system, maximizing its performance and lifespan. A clean system also helps reduce noise and improve heat distribution.Signs that you might need a power flush include cold spots on radiators, slow heating, frequent boiler breakdowns, or noises coming from your heating system. Discuss with your boiler installer whether a power flush is advisable for your specific situation.

How do I repressurize my boiler?

If the pressure gauge on your boiler is reading below 1 bar, you'll need to add water to the system. Consult your boiler's manual for specific instructions, or follow these general steps::1. Turn off your boiler and allow it to cool.2. Locate the filling loop. This is usually a flexible braided hose connected to your mains water supply and boiler, under the unit. It may have a valve or tap.3. Open both valves on the filling loop slowly, If your boiler uses a lever-type handle, consult the manual. You should hear water flowing into the system. .4. Keep an eye on the pressure gauge. When the pressure reaches the appropriate pressure, close both valves on the filling loop turning clockwise.5. Turn your boiler back on. Confirm that pressure is at an appropriate level. If problems persist, contact a qualified HVAC technician.If you're uncomfortable performing this task yourself, contact a Gas Safe registered engineer. Ensure your safety and avoid costly repairs by having it done right.