Furnace Repair Marysville

Frequently Asked Questions about Furnace Repair

What are the most common furnace problems?

Common furnace problems range from minor issues to major system failures, such as:

• No Heat or Reduced Heat Output: This can be caused by a faulty thermostat, a clogged air filter, or a malfunctioning igniter.
• Strange Noises: Listen for any sounds out of the ordinary.
• Short Cycling: This is when the furnace turns on and off too frequently, which can be caused by a faulty thermostat, an overheating furnace, or a clogged air filter.
• Pilot Light/Ignition Problems: In older furnaces, a faulty pilot light can prevent the furnace from igniting. In newer furnaces, issues with the electronic ignition system can cause similar problems.
• Blower Motor Issues: The blower motor circulates air through the furnace and ductwork. A malfunctioning blower motor can cause reduced airflow, uneven temperatures, and loud noises. should be addressed by a technician.
• Dirty Air Filter: A dirty filter reduces airflow and decreases furnace efficiency. . It may lead to more serious problems.
• Cracked Heat Exchanger: This is a serious safety hazard, as it can lead to carbon monoxide leaks. A cracked heat exchanger needs to be repaired or replaced immediately.

Don't attempt DIY repairs if you're not qualified.

What is the difference between a single-stage and two-stage furnace?

Single-stage and two-stage furnaces have operational differences.
Single-stage furnaces operate at only one output level – full capacity. This may cause uneven heating and fluctuating bills because the furnace is either running at its maximum setting or completely off..
Two-stage furnaces can run at both low and high speed. This allows the furnace to modulate its output based on the actual heating demand, resulting in more consistent temperatures, quieter operation, and improved energy efficiency. A two-stage furnace may be a more expensive initial investment, but it can provide greater comfort and savings over time.

What is a heat exchanger in a furnace?

The heat exchanger plays a key role in a furnace. It is responsible for transferring heat from the combustion process to the air that circulates throughout your home. . It's a safety feature separating exhaust gases. Cracks in the heat exchanger can be very dangerous, causing carbon monoxide to enter your house. Annual maintenance by a professional is highly recommended.

How can I tell if my furnace is the correct size for my home?

A properly sized furnace is essential for efficient and comfortable heating. An undersized furnace won't adequately heat the space. An oversized furnace will cycle on and off too frequently, wasting energy and shortening the system's lifespan.. Here are some signs your furnace may be improperly sized:

• High Energy Bills: An oversized furnace can cause increased energy consumption.
• Inconsistent Temperatures: Noticeable temperature fluctuations throughout your home.
• Short Cycling: If your furnace turns on and off frequently, it could be an indication and wasting energy.
• Poor Air Quality: If the airflow from the vents seems weak or there are hot and cold spots, the unit may be the wrong size.
• Excessive Noise: A furnace that's too large may produce more noise than normal.

If you suspect your furnace is improperly sized, it's essential to consult with an HVAC professional. A Manual J load calculation can accurately determine the appropriate furnace size.. Installing the correct size unit will maximize efficiency and minimize energy bills.