Boiler Installation Greenacres

Frequently Asked Questions About Boiler Installation

How long does it take to install a boiler?

Boiler installation typically takes one to three days, depending on the complexity of the job and whether you need to remove an existing boiler. . A straightforward swap or replacement of a like-for-like boiler might be faster, while a more complex conversion involving different piping or fuel types will take more time. . Your installer can provide a more accurate timeline after assessing your specific situation. .

What is a condensing boiler?

A condensing boiler is a type of high-efficiency boiler . They recapture and reuse exhaust heat. Condensing boilers increase efficiency and lower heating costs. They're better for the environment as well.

What is a combi boiler?

A combi boiler (combination boiler) provides both central heating and domestic hot water on demand, directly from the mains water supply. Unlike conventional boiler systems, a combi boiler doesn't require a separate hot water cylinder or a cold water storage tank in the loft, which makes them compact and ideal for properties where space is limited. Combi boilers are very popular in flats and houses with less hot water requirements since they deliver hot water instantly to taps and showers. Combi boilers are a good option for properties with one or two bathrooms.

How do I bleed my radiators?

If your radiators have cold spots or are not heating up efficiently, they may need to be bled to remove trapped air. Here's how to bleed your radiators: :1. Turn off your central heating system and allow the radiators to cool down completely. 2. Locate the bleed valve on the radiator. It's usually a small, square-shaped valve on one of the top corners. .3. Place a radiator key or a flat-head screwdriver on the bleed valve and carefully turn. You should hear a hissing sound as air escapes..4. Hold a cloth or container under the valve to catch any fluid that may drip.5. Continue turning the key until the hissing stops and water starts to come out steadily. .6. Tighten the valve clockwise .7. Repeat this process for all the radiators in your home.8. Once you have bled all the radiators, turn your central heating back on and monitor boiler pressure. The pressure should be between 1 and 1.5 bar when the system is cold. If the pressure is too low, you may need to top it up using the filling loop, if your boiler has one. If you are unsure how to do this, consult the manufacturer’s instructions or call a Gas Safe registered heating engineer. By bleeding radiators, you can improve their effectiveness and the overall performance of your central heating system.